home *** CD-ROM | disk | FTP | other *** search
- #!xchat
- # @(#) Hangup.Hayes V1.1 Tue Sep 1 14:04:25 1992 (Bob Denny)
- #
- # xchat script for hanging up a Hayes-type modem. When used with Taylor
- # UUCP, this script should be run as the dialer-complete and dialer-abort
- # script with xchat.
- #
- # Usage:
- # xchat Hangup.Hayes [ x ]
- #
- # where 'x' is any string. If it is present, this script will log the
- # modem reset as an ABORT reset, otherwise it will not log anything.
- #
- # Uncomment the lines starting with '###' to get debugging log.
- #
- start:
- ### dbgfile Hangup.Log
- ### dbgset 15
- zero
- sleep 2000 # Wait for trailing garbage
- flush # Toss it out
- ifnstr wakemodem 0 # No abort indicator
- log Hangup on abort
- #
- # Get modem's attention via Hayes 'escape' protocol.
- #
- wakemodem:
- sleep 4000
- send +++
- sleep 4000
- send \r
- timeout reset 2000
- expect reset OK
- #
- # We're (probably) in command mode. Use ATZ (reset) to hang up
- # as some modems don't behave well with ATH0 command.
- #
- reset:
- send ATZ\r
- timeout silent 5000
- expect done OK
- #
- # Finished, modem is back in initial state.
- #
- done:
- success
- #
- # No response to escape protocol. Log the error and force DTR low
- # in an attempt to get control of the modem. Then send ATZ just to
- # make sure.
- #
- silent:
- logerr Hangup: no response from modem
- hangup # Force DTR low as last gasp
- send ATZ\r
- sleep 5000
- failed
-